Job Reports > Vibro Hammers > Auckland

Cantebury
New Zealand
Foundation Construction

For this ICT project, pile foundation columns were created and the PTC30H1 Vibro Hammer was used to drive 900mm dia casing down 15m.

The site was excavated, the casings driven down, then drilled out to check bottom of the casing for solid ground,
thereafter a steel cage was laid and concrete poured into casings.

Once the casings were set and removed, the process was duplicated until all columns were completed and the floor
foundation was poured to begin construction.

The PTC 30H1 is available with single clamp for sheet piling and dual clamps for tubes.

ThyssenKrupp Steelcom format the unit to your requirements prior to supply. ThyssenKrupp Steelcom hire and sell impact and vibratory piling hammers ranging from
excavator mounted to large crane slung units, as well as,sheet pile and foundation equipment.

For further information contact Andy Fenn.
NZ + 09 576 3977

Click here to view the Job Report as a pdf